MagnaFlow RAM TRUCK 1500 Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 2)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 1.
Begin removing the OEM exhaust by
unbolting the clamp attaching the tail pipe assembly.
Disengage the welded hangers from the OEM rubber
Insulators using a pry bar or similar tool. Remove the
assembly.
Step 2. Next unbolt the OEM clamp attaching the
inlet muffler assembly to the outlet pipe of the flange
coupling. Remove the welded hangers from the rubber
insulators using a pry bar. Do not discard or damage
the insulators as they will be needed to install your new
system. There is a grounding strap that needs to be
unclipped. The OEM system may now be removed.
Step 3.
You are now ready to install your new
MAGNAFLOW system. Loosely attach the the Muffler
Assembly to the OEM pipe outlet using the supplied
3.00" clamp. Be sure to line up the large notch in the
pipe wiht the alignment peg. Engage the welded
hanger to the OEM rubber insulator. Leave all clamps
and hardware loose for final adjustment of the
complete system.
Step 4. Install the supplied hanger assembly using a
pre drilled hole in the drivers side sub frame and the
supplied hardware. This will be used with the supplied
rubber insulator to locate the new drivers side Mid Pipe
Assembly hanger. Slip the inlet of both Mid Pipes over
the outlet of the Muffler Assembly and loosely secure
using the supplied 2.50" clamp and 15mm socket.
Engage all welded hangers to the OEM rubber
insulators.
029
037
031
168
Step 5. Install both Tail Pipe Assemblies in a similar
fashion. Use the supplied rubber Insulator to locate the
drivers side welded hanger.
163