MagnaFlow TOYOTA TRUCK TACOMA Stainless Cat-Back System PERFORMANCE EXHAUST - Manual

Step 1: (Carefully read all instructions before
installation) Begin removal of the OEM exhaust
system by unbolting the (2) spring-loaded bolts
fastening the OEM exhaust system to the catalytic
converter. Do not discard or damage the OEM
fasteners or rubber insulators as they will be reused
to mount the new system. You can now disengage
the welded hangers from the OEM rubber insulators
and remove the system from the vehicle.
Step 2: Install the new inlet pipe assembly by fitting
the welded hanger into the rubber insulator, and by
bolting inlet flange to the catalytic converters reusing
the OEM fasteners. Leave all clamps and fasteners
loose for final adjustment of the complete system.
Fasten the muffler assembly to the inlet pipe
assembly using the supplied 2.50" clamp. Install the
tailpipe assembly by fitting the welded hangers into
the rubber insulators and by fastening it to the muffler
assembly using the supplied 3.00" clamp.
Step 3: With all components mounted loosely, adjust
the system for overall aesthetics and clearance of
frame & bodywork. (MAGNAFLOW recommends at
least 1/2" of clearance between the exhaust system
and any body panels to prevent heat-related body
damage or fire.)
Step 4: Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear. The supplied band clamps must be VERY tight
to properly align the pipes and prevent leaks
(Approximately 40ft-lbs). Inspect all fasteners after
25-50 miles of operation and retighten if necessary.
Mufflers, Converters,
Systems and Tips
INSTALLATION INSTRUCTIONS
15240
2013 Toyota Tacoma 4.0L
Warning: When working on, under, or around
any vehicle exercise caution. Please allow the
vehicle's exhaust system to cool before removal,
as exhaust system temperatures may cause
severe burns. If working without a lift, always
consult vehicle manual for correct lifting
specifications. Always wear safety glasses and
ensure a safe work area. Serious injury or death
could occur if safety measures are not followed.
** Magnaflow Performance Exhaust recommends professional
installation on all their products
Magnaflow Performance Exhaust - 22961 Arroyo Vista Rancho Santa Margarita, CA 92688
Main #: 1-800-990-0905 Technical Support: 1-800-959-9226 ext 4500
MAY 30, 2013
REV 000
INLET PIPE ASSY
MUFFLER ASSY
TAIL PIPE ASSY
[1] 3.00" CLAMP
[1] 2.50" CLAMP