MagnaFlow DODGE CHALLENGER SRT-8 HEMI Stainless Cat-Back System PERFORMANCE EXHAUST - Manual (Page 3)

MAGNAFLOW: 22961 Arroyo Vista - Rancho Santa Margarita, CA 92688 | 1(800) 990-0905
Technical Support: 1(800) 959-9226 | Email: [email protected]
Step 6. Insert all hanger assemblies into the rubber
insulators for for both passengers and drivers side
muffler assemblies. Now using the supplied 3.00"
clamps loosely secure them to the Tru-X assembly.
Step 7. The design of the new system allows for
either the supplied quad tips or reuse of the OEM tips.
Choose the desired look for your vehicle.
OEM TIP
QUAD TIP
Step 8. Attach each tip to the muffler outlet ball flare
using the supplied ball clamp and bolt. Loosely secure
using a 12mm socket.
Step 9. Once a final position has been chosen for the
new system, evenly tighten all fasteners from front to
rear using the torque specifications on page one of this
document. Inspect all fasteners after 25-50 miles of
operation and retighten if necessary.
FINISHED INSTALLATION, REAR VIEW
TAIL PIPE DETAIL