Introduction to controls and components, Preparing the remote control, Vcr operation – Panasonic NV-SJ200 User Manual
Page 5: 0 numeric buttons, Reset button, Audio out button, 0 infra-red transmitter, 0 chiid lock function buttons, To activate the child lock function, 0 cvc (crystal view control) indicator
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Introduction to Controls
and Components
Preparing the Remote
Control
VCR Operation
When you want to operate the VCR, set the VCR/TV switch ©
to “VCR”.
0
Numeric buttons
To select the programme positions (1-99) of the VCR.
Example:
9: 0
19: 0 - 0
- (
9
)
To enter numbers for various settings.
RESET button
To reset the tape counter (elapsed time) to “0:00.00”.
• The tape counter is automatically reset to “0:00.00”
when a video cassette is inserted.
® AUDIO OUT button
This button does not operate on this VCR.
VCR/TV button This button does not operate on this VCR. (D No function 0 No function 0 Infra-red transmitter 0 Chiid Lock Function buttons (Convenient function to prevent unauthorized use) remote control. Use this function, when you do not want other people to operate the VCR. To Activate the Child Lock Function: 1 Hold down the ENTER and the OFF (+) buttons © simultaneously until the “X hold” indication appears in • If you press a button while the Child Lock function is on, the “X hold” indication appears in the VCR display to inform you that no operation is possible. Indication when the Child Lock function Is activated To Cancel the Child Lock Function: 1 Hold down the ENTER and the OFF (+) buttons © simultaneously until the “X hold" indication 0 Cassette compartment 0 Infra-red Remote Control Receiver window 0 CVC (Crystal View Control) Indicator The crystal view control function ensure that you always picture automatically. While the VCR is turned on, the CVC indication 0 is always displayed to show that the Crystal View Control is 0VCR display Inserting Remote Control Batteries 1 Slide off the battery cover. 0) CD CQ 2 Insert the batteries with the polarity (© and ©) correctly 3 Replace the battery cover. Notes for Battery Replacement: However, it varies considerably depending on the frequency of use. • When they are exhausted, replace them with two AA, UM3, or R6 size batteries. • When the batteries are exhausted, remove them immediately and dispose of them correctly. • Make sure that the batteries are inserted with the polarity (@ and ©) correctly aligned. • Do not mix old battery with new battery. Manganese. • Do not use rechargeable (Ni-Cd) batteries. take out the batteries and store them in a cool, dry place. If the Sliding Cover of the Remote Control If the sliding cover of the remote control becomes detached accidentally, fit it securely in place by placing it on the top of below, and pushing it down until it clicks into position. • It is not possible to fit the sliding cover in place by pushing or sliding it on from the bottom end of the remote control. Correct
This function deactivates all buttons on the VCR and the
the VCR display.
disappears.
obtain the optimum picture quality so that you get the best
activated.
aligned.
• The service life of the batteries is approximately 1 year.
• Do not mix different battery types, i.e. Alkaline and
• Do not heat or short-circuit the batteries.
• When you do not use the remote control for a long time,
Becomes Detached
the remote control at the position shown in the illustration