Charging the battery – Panasonic DMC-F7A User Manual
Page 12
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Charging the Battery
[Preparation]
• Set the power switch to [OFF].
1
2
insert the battery into the camera.
(P11)
Connect the AC Mains Lead to the
AC Adopter and AC mains socket.
3
Connect the DC input Lead to the
camera.
•
The AC Mains Lead does not fit
entirely into the AC Adaptor socket. A
gap wili remain as shown O-
•
The green status indicator © biinks
and charging starts.
• During charging the battery, do not
open the battery door.
THE SOCKET OUTLET SHALL BE
INSTALLED NEAR THE EQUIPMENT
AND SHALL BE EASILY ACCESSIBLE,
i
4
When the status indicator stops
blinking, charging is complete.
• After charging is finished, remove the
AC adaptor from the electrical outlet
and then remove the connecting plug
from the DC IN socket.
■ Battery indicator
The remaining battery power is displayed on the LCD monitor. (This is not
displayed when using AC adaptor)
: The battery power is sufficient
H
e
I : The remaining power is a little low
: The remaining power is low
(-: Replace or recharge the battery
The status indicator also flashes. In this time, when pressing the shutter button
halfway, alarm sound rings.
12