Panasonic RX-DT39 - Manual (Page 8)

1
STOP/EJECT
TAPE/BSa TUNER CD
d^D
SELECTOR
BAND
I Il/(
J" J I
n i r n
U i- D U
5K1P/SEARCH
TUN/NG ^ /(
I I
Ì (H III
O O- I u
ÉE153
□
VOLUME
LMJ I / I f I
i f u L
I I
I
□
□
iktemisg to màio broadcasts
ff Set [SELECTOR] to “TUNER".
m
M
Press [BAND] to select “FiVì” or
Every time you press the button: FM AM.
Press [N^/-] or to tune in the broadcast
station.
Adjust the frequency until “ SIEID " Is displayed on the panel
{the display blinks or does not light when reception is weak).
Adjust the volume.
Automatic tuning:
This is a simple way of tuning in stations that have not been preset,
Keep depressed, and release it when the frequency
display starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic tuning, press ¡>^/-] or |[^>M/+] again.
Automatic tuning may stop without a station having been tuned in
when interference is encountered on neighbouring airwaves. In such
a case, tune in a station by tapping ¡1*#^/-] or
To turn off the unit:
Set [SELECTOR] to TAPE/S®".
If the tape is travelling, press STOP/EJECT] as well.
Adfustirag caiiter^nas P
For FM reception;
Pull out the telescopic antenna and adjust its length and angle for
optimum reception.
For AR/I reception:
Turn the unit in the direction which gives the best results.
Rèterencè.
Radio broadcasts may be hard to receive in a moving vehicle or in a
building because the signal may be weakened. In such cases, use the
unit near a window.
When there is a Sot of noise srs an FM stereo
broadcast ^
by :rémotè^dòritrp)ipn|y^^^
Reduce the interference by setting the sound to monaural.
Press [FM MODE/BPI.
“ fMONol ” is displayed.
To return to stereo reception, repeat the same, procedure to turn off
the “
IMONOI " display.
It is normally best to keep “ IMON oi
” off.
This way FM stereo programs will automatically be heard in stereo.