Panasonic AG-520D PROLINE - Manual (Page 36)

On-Screen Displays (OSD)
VCR Status & Clock Display
To display or
remove the
overlay.
Press DISPLAY.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
Function Status Counter
Rec Time —
Remaining
(OTR mode
only see
page 11.)
Current time
REC 12:00PM
-0:25 -0:12:34
SP
12/27/1999 MON
12:00PM - 1:00PM
CH 08 ABC MOVIE
MEMORIAL MOVIE
Channel
Caption
Asi
NO CH POUND
PLEASE CHECK /WTENNA
CABLE iXJNI^CTION THEN
PUSH CH UP AGAIN
PLEASE SET (X j OCK
BER^E РГЮ0№ШМ1Н0
Time Stamp Data Tape Speed
(see pages 26, 27.)
Channel & Function Display
When a function button is pressed (PLAY, FF,
etc.) or you change channels, the
Combination VCR mode or channel number
will be displayed.
(Some station names may also appear if
Channel Caption is set. See pages 24, 25.)
CHECK CASSETTE
РЕСОТШ TAB
TO cancel timer PtAY
HCMJ) DOWN STOP KEY
FOR APWOX 3 SEC
TO CANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
Blue Screen Display
Whenever a blank section of a tape comes up
in Play mode, or when the selected channel
has no broadcast signal with the “Weak
Signal Display ON/OFF” (page 23) set to
“OFF,” the TV screen will turn solid blue.
NO CASSETTE
PLEASE INSERT.A CASSETTE
R.EASE PREPARE
FOR TIMER REC
PLEASE PREPARE
FOR TIMER PLAY
36
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Playback,
Timer Recording or set the
On Timer and the Clock is
not set...
(see pages 6-8.)
If you push REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 11.)
If you push STOP during a
Timer Playback or Timer
Recording...
(see page 13, 15.)
If you push PLAY, FF,
REW, or REC on the
remote control or the
Combination VCR without a
cassette inserted...
(see pages 10, 11.)
If Combination VCR is not
in Stop mode or a cassette
is not inserted two minutes
before a Timer Playback or
Timer Recording is about to
begin...
(see pages 12-15.)