Panasonic AG-520D PROLINE - Manual (Page 20)

Tape Operation
Direct Access
(For Normal and/or Timer recordings)
Go directly to the desired recording.
Display INDEX screen.
Press INDEX in Playback or
Stop mode.
• If there are no Tinner Recordings
on the Program Index List, go to
step 3.
2
INDEX
PROGRAM INDEX SEARCH
INDEX SEARCH
SELECT
SET
END A V KEY
► KEY
INDEX KEY
Display INDEX screen.
-TN. I 1) Press A T to
I select "INDEX
' ! SEARCH.”
i 2) Press ► to
display.
• This screen appears
only if there are
Timer Recordings.
Select the recording
ni^ber.
Press
О О © NUMBERED
О 0 © keys.
0 I • To calculate number,
. below.
4 Start search.
Press FF or REW.
• When search is
finished, playback
To calculate the Index Number
Exannple 1:
If you are watching recording 4 and you want to watch recording 2, enter
3 in step “3” and press REW.
- f
1 2 I 3 4 5 6 7
Example 2:
If you are watching recording 2 and you want to watch recording 6,
enter 4 in step "3" and press FF,
1 2 3 4 5 6 7
NOTE: I indicates start points of each recording.
20
VHS Index Search System is ...
Each time recording is made, an
invisible index mark is placed on the
tape. When timer recordings are made,
program index and information are also
included. These index marks can be
used to access or scan recordings.
Model AG-520D unit is shown here.
SELECT/
SET
▲
▼
►
CH UP
CH DOWN
VOL UP
REW/®
Ut^yif 1Ъ*
о ©
©I
© ©
©■
о © ©
3
NUMBERED
keys
O b I iTipn^
mn.T ид»
(^3 угп*
F F o r R E W
* Make each entry within 10 seconds, or
the Index Search mode will be canceled.
• If these VHS Index Search Systems are
started very close to an index mark, that
index mark may not be counted in the
search.