Panasonic RX-ED77 - Manual (Page 18)

Preparation for Recording
Type of tape which can be used for recording
Automatically identifies the type of tapes.
Side to be recorded
faciiig up.
Normal position/TYPE I 0
High position/TYPE II 0
Metal position/TYPE W X
Insert the tape ivith the
exposed tape facing you.
This unit can not make a recording or erase correctly, if metal position
tapes are used.
load the tape in deck 2 with the side to be
recorded first facing up. El
The automatically selected when the cassette with the side to he
recorded facing up.
•When recording from the begining of a cassette
Wind the leader tape out, B
•When recording from the middie of a cassette
Stop the cassette at the position where recording is to begin.
il
J
" 1
i i Press REV MODE on the remote control to
1 S 1 select the mode. Q
1 Leader tape (on which nothing
1
' ^ 0 CXD: Records from the side facing up to the opposite side and
t
can be recorded)
?!
automatically stops.
Records only one side of the cassette and automatically stops.
REV MODE ■
Reverse mode
REV MODE
L
T D D C
1 n r c
:
n n n
u u u ^
*3
•You cannot operate deck 1 during recording,
"E" is displayed when you attempt to operate deck 1.
• Any change made to the volume or sound quality during recording
will not affect the recording.
• In order to prevent trouble caused by flat batteries, it is recom­
mended that you either supply power to the unit from the house­
hold AC outlet or replace all the batteries with new ones' when you
are recording something which is important to you.
• The recording level is set automatically.
Your attention is drawir to the fact that recording pre-recorded tapes
or discs or other published or broadcast material may infringe copy­
right laws.