Press band to display “lw”, "mw” or “fm, Press band to display “am” or “fm, Q press +■/►>] or “/ to select the station – Panasonic RX-ED77 User Manual
Page 12: Adjusting tfie antenna, For your reference, Am allocation setting, 0 press band to select fm, G) press and hold band for approximately 5 seconds, Listening to the radio, O ~ic n
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
listening to the Radio
TUNER
BAND
(a) LW MW FM
i__________ I
® AM -- FM
C
iwi
1
J (
O ~iC n
D l - t u
C
(tw
I
I »
QO
in
OQ lU
*3
\ ^ ✓
n t ( - b j (
JQ K'i
n M _3 3U
Press POWER.
(Only wheiT the batteries are used for the power supply)
For United Kingdom:
Press BAND to display “LW”, "MW” or “FM”.
The display changes each time the button is pressed. 0
For areas except United Kingdom:
Press BAND to display “AM” or “FM”.
The display changes each time the button is pressed, 0
Q Press +■/►>] or “/ to select the station.
+ /
: The frequency is increased.
— /
; The frequency is reduced.
Adjust the frequency until
is displayed on the panel
(the display blinks or does not light when reception is weak).
Automatic tuning:
Keep + /
or — / 1-^-^ depressed until the frequenc}'- display
starts to change. A station with good reception is automatically
selected and the selection process then stops.
To stop automatic timing, press + / or — / 1-4^ again.
• Pressing BAND will automatically turn the unit on and receive the
broadcasts which is previously tuned (only AC power is supplied).
•The automatic tuning may stop without a station having been tuned
in when interference is encountered on neighboring airwaves. In
such a case, tune in a station by tapping + /
or — / K4.
Adjusting tfie antenna
For FM reception: E3
Adjust the length and direction of the whip antenna.
For AM (LW/MW) reception; B
Adjust the direction in which the main unit is pointed.
For your reference:
Radio broadcasts may be hard to receive in a moving vehicle or
building because their signals are weak. In such cases, use the unit
near by a window.
For areas except United Kingdom:
AM allocation setting
Before receiving the AM broadcasts, be sure to select the correct
allocation setting (either 9 kHz or 10 kHz) according to your area.
0 Press BAND to select FM.
(g) Press and hold BAND for approximately 5 seconds.
The frequency display will be returned to the minimum fre
quency of the AM band and the display wtU begin to flash. Keep
holding for approximately 5 more seconds.
E
(
3
)
When the display stops flashing and Indicates a differ
ent frequency number, release BAND. E
To return to the original frequency, repeat steps 1 to 3 above.