With a dss receiver, Audioa/ideo connections – Panasonic OMNIVISION PV-8200 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
With a DSS Receiver
You can:
1)
Record and view any channel including
scrambled channels; channel selection
must be made at the DSS Receiver.
2) Program one channel for unattended
recording.
NOTE: The DSS receiver must be turned off to
view programs from a cable box or
antenna. See the DSS manual for details.
IN FROM
CABLE or Antenna
IN FROM
Satellite Dish
OUT TO TV
VHF/UHF
•DSS® is a registered trademark of DIRECTV, INC., a unit of GM Hughed Electronics.
AudioA/ideo Connections
If your TV has AUDIO IN and VIDEO IN terminals, you can connect your
VCR to them to receive a higher quality picture and sound. If your TV is not
stereo, you can connect a stereo amplifier to the VCR to enjoy stereo sound.
1
Connect the VIDEO OUT terminal on the VCR to the VIDEO IN terminal of your TV.
2
Connect the AUDIO OUT terminals on the VCR to the AUDIO IN terminals of your TV.
3
Set the VIDEO/TV selector of your TV (Monitor/Receiver) to “VIDEO."
NOTE:
To use your TV as a VCR monitor, set the VIDEO/TV selector on the TV (Monitor/Receiver) to "VIDEO."
Note to CABLE system installer:
This reminder is provided to call the CABLE system installer’s attention to Article 820-40 of the NEC in USA (and to the
Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in particular, specifies that the
cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.