Panasonic OMNIVISION PV-8200 - Manual (Page 22)

Tape Operation (continued)
•Important; If the remote control POWER, ACTION, PROG, CHA/T , INDEX, or ADD/DLT button does
not work when pressed, press the VCR button on the remote and try the button again.
Your VCR is equipped with
several time saving features as
well as convenient automatic
functions making tape operation
easier than ever.
Repeat Play
The VCR will play your recording over and over
1 Press ACTION* * to display
the menu.
Press AT to select “SET UP
VCR,” and then press ► to
display the “SET UP VCR” screen.
— MENU
SET CLOCK
SET UP CHANNEL
IОI ОМА/ LANGUE: ENGL I SH
SELECT;* T KEY
SET :► KEY
END :ACT I ON KEY
Press
AT
to select “REPEAT
PLAY,” and then press ► to
select “ON” or “OFF.”
• When “ON” is selected the VCR plays
the tape to its end or until a blank
portion of over 30 seconds is detected
(erased portions are not considered
blank). The tape is then rewound and
played again and again until Repeat
Play is turned off.
--------- SET UP VCR-------------
ON
ON
BEEPER
NOISY CM BLUE BACK: ON
SELECT;* ▼ KEY
SET :► KEY
END lACTiON KEY
Press ACTION twice to return to the normal screen.
Zero Search
To quickly return to a specific tape location.
3 Press DISPLAY to display
the Time Counter overlay
during playback.
b
Press COUNTER RESET
to reset the Time Counter to
“0:00:00" at the desired position.
STOP 12;00AM CH 08
0:00:30
SP
One Minute Skip
The VCR rapidly skips over one minute of tape.
A
Press ZERO/1 MIN in Play mode.
• The VCR will go into FF search mode and
skip over 60 seconds of recorded time.
Normal playback will then resume.
C
Continue playback, rewind,
or fast forward.
Press ZERO/1MIN in Stop mode
when you want to return to
“0:00:00.”
• The VCR will go into FF or REW mode
and stop at the last point the Time
Counter was set to 0:00:00.
12;00AM CH OB
0:00:00
SP
22