Panasonic 8-DISC CD CHANGER CX-DP801EUC - Manual (Page 15)

Installation Guide
□ Precautions
If possible, this equipment should be professionally installed. In case of difficulty, please consult with your near­
est professional installer.
1, This unit operates only in a 12-volt DC negative ground system.
2. Before performing installation and wiring, remove the negative {-) terminal of the battery. {See Note Below.)
Note: Do not disconnect the negative battery terminal in vehicles with trip or navigational computers.
All electronic memory settings previously registered will be lost. Take extra care to avoid short circuiting
when installing the unit.
3. Follow the wiring connections diagram carefully to avoid causing damage to the unit.
4. Insulate all exposed wires to prevent short circuiting.
5. Secure alt loose wires after installing the unit.
6. First, connect the extension cord © (supplied) to the CD changer and then, connect RCA pin connectors and
the extension cord 8p DIN connector to the tuner deck amplifier. Finally, connect the battery cord to a constant
power supply.
7. Please carefully read the operating and installation instructions of any equipment connected to this unit.
8. If the unit doesn’t work after pressing other buttons, press the reset switch. If pressing the reset switch does­
n’t restore normal operation, refer to the enclosed Servicenters list or in USA call 1-800-545-2672 for your
nearest MSC Servicenter.
□ Installation Hardware
Description Q’ty
© Hex. Bolt with Double Washers (M4 x 8) 4
© Base Bracket 2
© Hex. Nut (M5) 4
m Mounting Bracket (L) 1
© Mounting Bracket (R) 1
Double-Faced Adhesive Tape 2
CX-DP801EUe
15