Panasonic PVQ-M2508 - Manual (Page 10)

On-Screen Displays (OSD)
Channel & Function Display
Whenever the channel is
changed, the channel
number will appear for a few
seconds on-screen.
(Some station names may
also appear if Channel
Caption is set. See page 20.)
When a function button is
pressed (PLAY, FF, etc.), the Combination VCR
mode will be displayed.
• When a recording is started, both REC and
the channel number will appear together.
Warning and Instruction Displays
These displays will alert you of a missed operation or
provide further instructions.
If no active channels are
found for CHANNEL
MEMORY...
(see page 5.)
If you attempt to set or
review a Timer Recording or
set the On-Timer and the
Clock is not set...
(see pages 8, 9.)
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH CH UP KEY AGAI N
PLEASE SET CLOCK
BEFORE programming
Menu Screen
1 Press ACTION to
display the MAIN
MENU.
2 Press and
ACTION to make your
selection (see page 8).
• To get the most from each
feature, please read the
Operation Manual before
attempting any operation.
If you press REC on the
remote control or the
Combination VCR, and a
cassette is inserted with no
record tab...
(see page 16.)
If you press STOP
during a Timer
Recording...
(see page 19.)
CHECK CASSETTE
RECORD TAB
TO OANCEL TIMER REC
HOLD DOWN STOP KEY
FOR APPROX 3 SEC
VCR Status & Clock Display
Press DISPLAY to display and remove the
overlay shown below.
Function Current Channel Caption
Status Time (See page 20.)
Blank Tape/ No Video Signal Indication
Whenever a blank section of a tape comes up
in Play mode, or when the selected channel
has no broadcast signal with the “Blue Back
ON/OFF Feature” (page 21) set to ON, the TV
screen will turn solid blue.
If you press PLAY, FF,
REW, or REC on the
remote control or the
Combination VCR without
a cassette inserted...
(see pages 15,16.)
If the Combination VCR is
not in Stop mode or a
cassette with record tab is
not inserted two minutes
before a Timer Recording
is about to begin...
(see pages 18,19.)
If head cleaning becomes
necessary while playing
back a tape...
(see page 25.)
If you press a function
button other than
STCP/EJECT or POWER
while the Combination VCR
is in VCR Lock mode...
(See page 21.)
NO CASSETTE
PLEASE INSERT A CASSETTE
VIDEO HEADS MAY
NEED
cleaning
PLEASE INSERT HEAD
cleaning cassette
OR REFER TO MANUAL
END:PLAY KEY
VCR LOCK ACTIVATED
10