Panasonic TC-29GA30R - Manual (Page 24)

1
III "■----------------------- --
1
DISPLAY
□
TV/AV
□
PRE.
□ □ □ □
- V A
L... j 1
6 4
© a
® ( i
How to switch the power ON or OFF
The TV set must first be switched on at the
wall outlet and at the Power Switch. (Refer to
page 8).
Push this button to turn the TV set ON, from
STANDBY mode.
Push it again to turn the TV set OFF,
STANDBY mode.
Note:
It is also possible to turn the TV set on
STANDBY by pushing the “Direct Pro­
gramme Number Selection" Buttons (0-9)
and the “Programme Number Up or Down"
Button, either on the set or on the Remote
Control.
Programme Number Selection
Push the Programme Number Up
“ a ”
or
Down “v” Button to select the next higher or
lower Programme number.
Direct Programme Number Selection
(CH SELECT = POS.)
You can select the numbers directly by
pushing “Number 0 - 9 ” button and the two
digit Numbers by pushing Two Digif and
“Programme Number” buttons.
Programme Numbers...
Programme Number 12.
©.®.@
Direct Programme Number Selection
You can select the number directly by push­
ing the corresponding programme number
button.
Programme Number 8.......... (J)
Programme Number 36........(T)»®
Programme Number 124.,,. ® , ® , ®
Note:
When the Skip setting for Programme
Number 100 through 125 is on, the channel
selection time will be shorted, and thus you
can not input three digits at a time.
TV/AV
TV/AV Mode Selection
Push the TV/AV" Button to select TV, AV1,
AV2, AV3 input signal modes sequentially.
TV/A