Panasonic NV-G25 Series - Manual (Page 16)

RECORDING Preparation
•Insert a video cassette with the erasure prevention tab
intact.
When a video cassette is already inside the VTR, press
the VTR On/Off Switch to turn it on.
•Make sure that the Timer Record Button is set to "Off".
•Reset the Tape Counter to "0:00.00".
•Set the VTR/TV Selector to "VTR".
•Set the Tape Speed Selector to "SP" or "LP.
"*-.7^*^■.*,***-,;*''
REWVSii PLAY ©/FF STOPPI
oc ► ■ ^
Tape Speed Selector
For recording either of two tape speeds can be selected.
During playback the recorder automatically selects the
correct speed.
Select the desired tape speed with the Tape Speed
Selector before recording.
•Set to the "SP” position for normal speed.
•Set to the "LP” position for slow speed.
The corresponding indicator (SP or LP) lights up during
recording and playback.
—
It is not recommended to change from the SP to the
LP mode or vice versa in the middle of recording.
Even if the switching is done while the VTR is in the
pause mode, picture distortion will occur at the
switching point during playback.
O Select on the VTR, the programme position (channel)
to be recorded. In order to confirm proper reception,
turn on the TV set and select the video playback
channel (AV).
r
/ n
t u
I ^
_____ )
Q Press the Record Button (•).
REC#
REC
When a video cassette with broken out tab is inserted,
it will be ejected automatically.
•During recording, the programme position (channel)
on the VTR cannot be changed.
If You Wish to Avoid Recording Unwanted Material
e
Press the Pause/Still Button ( I I ) to stop the tape
temporarily.
PAUSE/STILL
REC
OD
•Press the Pause/Still Button (II) again to continue
the recording.
•If you leave the VTR in the pause mode for more than
5 minutes, the VTR will automatically switch over to
the stop mode to protect the tape and the video
heads.
To Finish the Recording
O Press the Stop Button (■).
Recording One TV Programme While Watching
Another
You can watch one programme on the TV while recording
another on the VTR.
1. Record (following steps O ^nd 0).
2. Set the VTR/TV Selector to "TV”.
3. Select the desired programme position (channel) on
your TV set.
•Disconnect all cables from the Video Input and
Audio Input Sockets before starting the recording. If
they remain connected, it is impossible to record TV
programmes.