CatEye MODEL EC-1600 - Manual (Page 7)

6
Assembly
1. Attaching the legs
• Remove the two screws from the
respective leg pipes. The one with
casters should be used as front leg.
• Place the front leg under the front
end of the main body with casters
facing forward, and adjust the po-
sition so that the screw holes meet
the fastening points.
• Fasten the leg with the two screws
securely.
2. Mounting the handlebar
post
• Remove the handlebar post knob.
• Insert the handlebar post into the
main body, with the post holes fac-
ing forward.
• Adjust the post position so that
the lowest post hole of the three
meets the post knob screw hole,
and fasten the post knob securely.
It will be easier to screw in if you
slightly lift the handlebar post.
3. Connecting the control
cable
• Connect the connector from the
handlebar post cover with that
from the body in correct direction,
keeping the lower connector cable
at the center of the post front.
• Slide down the inner post cover
and squeeze it into the body until
it clicks in position.
handlebar post
handlebar post knob
loosen
tighten
screw
leg pipe
caster
Front
• Hook the leg cover at the end of
each leg and fix it in position with
adhesive tape as illustrated.
Note: When placing leg covers,
follow the location markings
on the back thereof.
OFF
screw
Rear
leg pipe
leg cover
hook
Adhesive tape
F-L
connectors
squeeze in
outer post cover
inner post cover
Note: Watch the cable connec-
tors when sliding down the in-
ner post cover.
7
4. Mounting the saddle
• Pull the spring lock pin and lift up
the seat post to a proper height for
saddle mounting.
• Mount the saddle onto the top of
seat post in position and tighten
the nuts with wrench No.15.
5. Attaching the pedals
• Use the No.15 end of the spanner
to attach the pedals firmly to the
cranks.
• The right and left pedals are dif-
ferent, so be sure to check for R
and L marks.
• Tighten the right pedal by turning
clockwise, and the left pedal by
turning counterclockwise.
Caution: If the pedals are not at-
tached firmly enough to the
crank, they can cause an irri-
tating noise. Be sure to attach
them firmly.
crank
left (L) Front right (R)
wrench No.15
seat post
Saddle
wrench No.15
crank
1
4
1
5
2 3
F-R
R-R
R-L
ON
OF F
EC-1600