beautypg.com

CatEye Single Shot Plus HL-EL610RC User Manual

Cateye single shot plus, Hl-el610rc, On off hi low flash

background image

HL-EL610RC

CATEYE SINGLE SHOT PLUS

Pat. and Design Pat. Pending

Copyright© 2007 CATEYE Co., Ltd.

EL61RC-070620 066640131 1

*1

Dial

Screw

Release button

Bracket rubber pad

Bracket

Bracket strap

Light unit

2

3

4

6

ON

OFF

Hi

Low

Flash

2 sec.

Double press

Double press

Switch

Charge jack

Battery charger

To AC power outlet

Battery indicator

1

2

Charging Indicator

x1

#533-8827

H34 Bracket

#534-1865

NiMH 4.8v 2700mAH

UL:#534-1866

UK:#534-1867

EC:#534-1868

AS:#534-1870

CHR-2700mAH 4.8v NiMH

SPARE PARTS

2

3

1

Screw

Lens unit

Battery

Body

Battery connector

Rubber packing

OK

NO!

Back side of lens

Rubber packing

Service & Research Address for USA

CATEYE Service and Research Center 1705 14th St. 115 Boulder, CO 80302

Phone : 303.443.4595 Toll Free : 800.5CATEYE

Fax : 303.473.0006

E-mail : [email protected]

URL : http://www.cateye.com

CO.,LTD.

2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan

Attn : CATEYE Customer Service Section Phone : (06)6719-6863 Fax : (06)6719-6033 E-mail : [email protected] URL : http://www.cateye.co.jp

Standard charg-

ing time

Blinking red light : Charging

Green light

: Charging is completed Approx. 4 hours

Charging indicator state

ON

OFF : Long press

Hi

Low : Single press

Flash

: Quick double press

Hi

: About 3 hours

Low : About 9 hours

Flash : About 36 hours

Switch

Standard continu-

ous lighting time

FOR SAFE OPERATION

Do not place it within children's reach.

In preparation for unexpected battery shutoff, we recommend you carry a dry-cell

battery light unit with you.

If the light unit or parts become dirty with mud, etc., clean with a soft cloth which is

moistened with mild soap. Never apply paint thinner, benzine or alcohol; damage

will result.

Mount the light unit more than 10 cm away from the wireless meter. When it is

mounted too close, the transmission may be affected adversely.

This product has waterproof features that allow you to use it in rain. Do not use it

soaked in water.

Before Initial Use

Before shipment, it is charged enough to check the light. Be sure to charge it before use,

according to the instructions "How to charge."

INTRODUCTION

Before using the light, please read this manual and the attached “NiMh

Batteries” thoroughly, and keep them for future reference.

Thank you very much for purchasing the CATEYE "SINGLE SHOT PLUS HL-EL610RC."

This product is a high power rechargeable light unit that integrates a high power LED and

a nickel metal-hydride rechargeable battery into a compact body.

SPECIFICATIONS

Light source

High power white LED x 2

Battery

NiMH 4.8v 2700mAH

Battery charger

CHR-2700mAH 4.8v NiMH

Operating time

Hi

: Approx. 3 hours

Low : Approx. 9 hours

Flash : Approx. 36 hours

Standard charging time

Approx. 4 hours

Temperature range Charging : 32˚F – 104˚F (0˚C – 40˚C)

Operating : 5˚F – 113˚F (-15˚C – 45˚C)

Recharge/discharge number of times

About 300 times (until the rated capacity drops to

50%)

Dimensions/weight 4-3/32” x 2-29/32” x 1-11/16” (104 x 74 x 43 mm) /

8.92 oz (253 g)

The specifi cations and design are subject to change without notice.

*

3

How to charge

Open the charge jack cover at the

back of the light unit to connect the

battery charger plug.
Plug the battery charger to an

AC outlet.
After charging, remove the plug

and close the charge jack cover.

1�

2�

3�

HOW TO MOUNT

HOW TO REPLACE BATTERY

HOW TO USE

1

Lighting (lighting pattern selection)

The lighting pattern is selected using a switch.

Be sure to use the special purpose battery

charger.
Charging and lighting times are approximate

values, and will vary by environmental and

user conditions.

*

*

2

Remaining battery capacity

When the battery indicator lights up red, the bat-

tery is almost shutoff. Charge the battery as soon

as possible.

COMPONENTS

Light unit

H34 Bracket

Battery charger

Wrap the bracket strap around the

handlebar, and put it in the dial.
Securely tighten the strap by turn-

ing the dial.
Cut off the excess bracket strap

extending from the dial.
I n s e r t t h e l i g h t u n i t t o

the bracket until it clicks.

To remove, pull out while pressing

the release button.

CAUTION!:

Make sure to tighten the dial by

hand. If you tighten it too hard

with a tool, the screw threads may

be stripped.

When the angle adjustment on the

right and left sides is loose, tighten

the screw ( ).

Round off the cut edge of the

bracket strap to prevent injury.

How to Adjust Beam Angle

Slightly loosen the dial on the

bracket.
Adjust the light unit angle so that

the light is not directed to oncom-

ing cars.

When the dial is too fi rm to loosen, wash it

slightly with water to loosen it.
Do not loosen the dial too much, or the bracket

strap may come off. Loosen the dial just enough

to allow the bracket to move slightly. Securely

tighten the dial after adjusting the strap.

It can also be adjusted 10 degrees to the left

and right.

1�

2�

3�

4�

5�

6�

*

*

*

Turn over the light, and remove the 2

screws at the front of the lens using

a 2.5 mm Allen wrench.
Slowly pull out the lens unit from

the body.
Remove the battery connector con-

nected to the board, and replace it

with a new battery.
Place the battery on the tray, and

insert it to the body in place, and

secure it with 2 screws.

CAUTION!:

The lens unit is a precision part;

therefore, never disassemble

it. Otherwise, the optimum light

distribution may be lost.

To maintain its waterproof features,

assemble the lens unit with a rubber

packing-sheet correctly.

In order to avoid cable damage,

when re-assembling the light,

make sure the battery cable is

placed inside the rubber seal as

shown below.

1�

2�

3�

4�

LIMITED WARRANTY

2-year Warranty: Light unit / Battery charger
(Deterioration of the battery is excluded.)

CatEye products are warranted to be free of defects from materials and workmanship for a period of 2 years from original

purchase. If the product fails to work due to normal use, CatEye will repair or replace the defect at no charge. Service must

be performed by CatEye or an authorized retailer. To return the product, pack it carefully and enclose the warranty certifi cate

(proof or purchase) with instruction for repair. Please write or type your name and address clearly on the warranty certifi cate.

Insurance, handling and transportation charges to CatEye shall be borne by person desiring service.

For UK and REPUBLIC OF IRELAND consumers, please return to the place of purchase. This does not affect your statutory rights.

ENG