Yamaha RX-V730 - Manual (Page 31)

BASIC PLAYBACK
Selecting a sound field program
You can enhance your listening experience by selecting a
DSP program. For details about each program, see pages
30 to 34.
^ Press one of the DSP program buttons on
the remote control to select the desired
program.
The name of the selected program appears on the
front panel display.
Program name
, P G T L
D-TV/CSl. , DVD , MD/CM TUNER CD PHONO
VOLUME
’ illlllllll
■j p’ j“*, T, j“*,
ET
After selecting the desired program, press
the same button repeatedly to select the
desired sub-program if available.
Example: Pressing MOVIE THEATER 1 repeatedly
switches the sub-program between
“Sci-Fi” and “Spectacle”.
Program name
IffiRa/M VCR 1 V-|il X EfTV/t®. , EM3 , MD/CM TUNER CD PHONO
VOUJME
TR1 .illllllll
S c i F i .
Sub-program name
Notes
Sub-program name
• There are 9 programs with sub-programs available with this
unit. However, the selection depends on the input signal format
and not all sub-programs can be used with all input signal
formats.
• The digital sound field processor cannot be used when a source
connected to the 6CH INPUT jacks of this unit is selected or
when 96-kHz sampling digital signals are input to this unit.
• The acoustics of your listening room affect the DSP program.
Minimize the sound reflections in your room to maximize the
effect created by the program.
• When you select an input source, this unit automatically selects
the last DSP program used with that source.
• When you set this unit in the standby mode, the current source
and DSP program are memorized and are automatically
selected when you turn on the power again.
• If a Dolby Digital or DTS signal is input when the input mode
is set to AUTO, the DSP program (No. 7-9) automatically
switches to the appropriate decoding program.
• When a monaural source is being played with PRO LOGIC/
Normal or PRO LOGIC/Enhanced, or PRO LOGIC II Movie,
no sound will be heard from the main speakers and the rear
speakers. Sound can only be heard from the center speaker. (If
“1A CENTER” on the SET MENU is set to NON, the center
channel sound is output from the main speakers.)
\i/
• You can also select DSP program by pressing PROGRAM
<3 / C> on the front panel.
• Select a program based on your listening preference. Program
names are just for reference.
27