Connecting the antennas, Connecting the am loop antenna, O ®m – Yamaha RX-V730 User Manual

Page 21

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connecting the antennas

CONNECTIONS

Both AM and FM indoor antennas are included with this
unit. In general, these antennas should provide sufficient

signal strength.

Connect each antenna correctly to the designated
terminals.

AM loop antenna

(included)

O
®M

©M

Indoor FM
antenna
(included)

Ground (GND terminal)
I 'oi' maximum safety and minimum

interference, connect the antenna GND

terminal to a good earth ground. A good

earth ground is a metal stake driven into

moist earth.

75-ohm/300-ohm antenna adapter (U.K. model)

11 (7/16)

8(5/16) I

Unit:

Open the cover ot the

included 75-ohm/300-ohm

antenna adapter.

Lead wire

6 (1/14)

mm (inch)

Cut the external sleeve

of the 75-ohm coaxial
cable and prepare it for
connection.

Clamp

with

pliers.

Cut the lead wire and

remove it.

Clamp with
pliers.

Insert the wire

the cover into

into the slot. place.

Insert the cable wire into the

slot, and clamp it with pliers.

■ Connecting the AM loop antenna

11 Set up the AM loop antenna, then connect it.

^ Press and hold the tab to insert the AM loop

antenna lead wires into the AM ANT and
GND terminals.

Orient the AM loop antenna for the best

reception.

Notes

• The AM loop antenna should be placed away from this unit.
• The AM loop antenna should always be connected, even if an

outdoor AM antenna is connected to this unit.

A properly installed outdoor antenna provides clearer

reception than an indoor one. If you experience poor
reception quality, an outdoor antenna may improve the

quality. Consult the nearest authorized YAMAHA
dealer or service center about the outdoor antennas.

FM/AM

0kHz/9kHz

lOC&Hz/IOkHzT

FREQUENCY STEP switch (China and General

models)

Because the interstation frequency spacing
differs in different areas, set the
FREQUENCY STEP switch (located on
the rear panel) according to the frequency
spacing in your area.
North, Central and South America:

100 kHz/10 kHz

Other area: 50 kHz/9 kHz
Before setting this switch, disconnect the
AC power plug of this unit from the AC
outlet.

■D