Yamaha RX-V730 User Manual

Page 27

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

ADJUSTING SPEAKER OUTPUT LEVELS

LEFT

RIGHT

* Subwoofer test tone is output after the rear left

speaker (LEFT SURROUND).

For your convenience, the state of the test tone
output is also shown on the monitor by an image of
an audio listening room.

The front panel display also shows which speaker is

outputting the test tone.

Note

• If the test tone cannot be heard, turn down the volume, set this

unit to standby mode and check the speaker connections.

Adjust the level of the

effect speakers using < / >

so that it matches the
level of the main
speakers.

While adjusting, the test tone

is heard from the selected
speaker.

Note

•

aajust the level of the main speakers, use VOLUME knob

(or VOL +/- on the remote control).

lil When adjustment is

complete, press TEST to
stop the test tone.

Notes

• If “1A CENTER” on the SET MENU is set to NON, the center

channel sound is automatically output from the main left and

right speakers.

• If “1C REAR LR” on the SET MENU is set to NON, the

output level of the rear left, right and center speakers cannot be
adjusted in step 4. The test tone will be circulated skipping the

rear left and right speakers and the rear center speaker.

• If “ID REAR CT” on the SET MENU is set to NON, the

output level of the rear center speaker cannot be adjusted in
step 4. The test tone will be circulated skipping the rear center
speaker.

• If “IE BASS” on the SET MENU is set to MAIN, the test tone

will be circulated skipping the subwoofer.

\i/

• It is not necessary to readjust the speaker levels once they are

set (as long as you do not change the speakers). You can enjoy
listening to or watching the input source at the desired volume
simply by adjusting the VOLUME knob (or VOL +/- on the

remote control).

• If the output level of the effect speakers (center, rear left, rear

right, and rear center) cannot be increased enough to match the

level of the main speakers, set “IF MAIN Lv” on the SET

MENU to -10 dB (see page 44). This setting decreases the

main speaker output level to about one-third of the normal
level. After you have set “IF MAIN Lv” on the SET MENU to

-10 dB, adjust the levels for the center and rear speakers again.

■D