Yamaha RX-V730 - Manual (Page 26)

ADJUSTING SPEAKER OUTPUT LEVELS
This section explains how to adjust speaker output levels
using the test tone generator. When this adjustment is
complete, the output level heard at the listening position
should be the same from each speaker. This is important
for best performance of the digital sound field processor,
and the various decoders (Dolby Digital, Dolby Pro
Logic, Dolby Pro Logic
II and DTS).
Using the test tone
Use the test tone to balance the output levels of the
speakers. The adjustment of each speaker output level
should be made at your listening position using the
remote control.
unit.
Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
El Set the BASS and TREBLE controls on the
front panel to the center position.
11 Press AMP to select the
AMP mode.
“AMP” appears in the display
window on the remote control.
^ Press TEST to output the
test tone.
ET
Adjust the volume of this unit so you can
hear the test tone.
The test tone is heard (in order) from the main left
speaker, center speaker, main right speaker, rear right
speaker, rear center, rear left speaker, and the
subwoofer. The tone is produced for 2.5 seconds
from each speaker.
Front panel Remote control
22