Loading and unloading cassettes, Loading a cassette, 1 turn the power switch on – Yamaha DTR2 User Manual
Page 15: Place a dat cassette in the cassette holder, Unloading the cassette, 2 remove the cassette from the cassette holder, Notes
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
LOADING AND UNLOADING CASSETTES
Loading a cassette
1
Turn the POWER switch ON.
2
Press the OPEN/CLOSE button
{ ± )
to open the
cassette holder.
"OPEN" flashes on the display.
Place a DAT cassette in the cassette holder.
Be sure the window of the cassette faces you and the
slide tab faces you on the right side.
Press the OPEN/CLOSE button (^) again to close
the cassette holder.
Unloading the cassette
1
Press the OPEN/CLOSE button
(A)
to open the
cassette holder.
2
Remove the cassette from the cassette holder.
3
Press the OPEN/CLOSE button (^) again to close
the cassette holder.
NOTES:
•
The cassette holder will not close completely if the tape
is inserted Improperly. In this case, press the OPEN/
CLOSE button
(±)
to open the cassette holder and
insert again.
•
If the cassette holder does not close completely, It will
automatically open after about 10 seconds even if the
OPEN/CLOSE button (A) is not pressed.
•
Do not attempt to open or close the cassette holder by
hand. Doing so will damage it.
15