When using the coaxial digital jacks, When using the optical digital jacks, Notes – Yamaha DTR2 User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Connecting to another digital audio tape deck, or an amplifier, etc. which has digital jacks
•
When this unit is connected to another DAT deck,
amplifier or other digital source, such as a CD player
with digital jacks, digital-to-digital recording will be
carried out.
•
Be sure to disconnect the power cords of both
components from the AC outlet before connecting.
When using the COAXIAL DIGITAL jacks
1
Connect the COAXIAL DIGITAL INPUT jack to the
coaxial digital output jack and the COAXIAL DIGITAL
OUTPUT jack to the coaxial digital input jack of another
DAT deck, or amplifier, etc. using the coaxial cables.
2
Set the DIGITAL INPUT selector to the COAXIAL
position.
When using the OPTICAL DIGITAL jacks
1
Connect the OPTICAL DIGITAL INPUT jack to the
optical digital output jack and the OPTICAL DIGITAL
OUTPUT jack to the optical digital Input jack of another
DAT deck, or amplifier, etc. using the optical fiber
cables.
2
Set the DIGITAL INPUT selector to the OPTICAL
position.
NOTES:
•
When the POWER switch is turned on, the inside of the
OPTICAL OUTPUT jack Illuminates red. This red light
(which is completely harmless) is used to send the
digital signal.
•
Do not fold or bend the optical fiber cable because It
damages easily.
11