8 press ©enter to confirm your selection, 9 press ©<] / > to select the desired setting, 10 press ©enter to confirm your selection – Yamaha OWNER'S MANUAL HTR-6130 User Manual
Page 27: 11 press ©a / v to select a speaker and then, L / o to adjust the balance, 12 press ©menu to exit from “basic setup, Checks, Check uk, Fr ........ i i
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic setup
1
Press ©V to select “SET” and then ©
to select the desired setting.
Choices: SET,
CANCEL
• Select “SET” to apply the settings you made.
• Select “CANCEL” to cancel the setup procedure
without making any changes.
You can also press ®MENU to cancel the setup procedure.
8
Press
©ENTER
to confirm your selection.
If you selected “SET” in step 7, each speaker outputs
a test tone twice in turn. “CHECKiTestTone” appears
in the front panel display for a few seconds and then
“CHECK OK?” appears in the front panel display.
CHECKS
• Check the speaker connections (see page 5) and adjust the
"SPEAKERS” settings back in step 6, if necessary.
• The indicator of the speaker currently outputting the test
tone flashes in the front panel display.
9
Press ©<] / > to select the desired setting.
CHECK UK
■^ES
Choices:
YES,
NO
• Select “YES” to complete the setup procedure if
the test tone levels from each speaker were
satisfactory.
• Select “NO” to proceed to the speaker level
adjustment menu to balance the output level of
each speaker.
10
Press
©ENTER
to confirm your selection.
• If you selected “YES” in step 9, the setup
procedure is completed and the display returns to
the top set menu display. Press
©MENU
to exit
from “BASIC SETUP”.
• If you selected “NO” in step 9, the front speaker
level adjustment display appears in the front panel
display.
11
Press
© A
/
V
to select a speaker and then
©
The selected speaker and the front left speaker (or the
surround left speaker) output a test tone in turn.
• Press ©1> to increase the value.
• Press © FR ........ I I......... • Select “PR” to adjust the balance between the front left and right speakers. • Select “C” to adjust the balance between the front left and center speakers. • Select “SL” to adjust the balance between the front left and surround left speakers. • Select “SR” to adjust the balance between the surround left and surround right speakers. • Select “SWPR” to adjust the balance between the front left speaker and the subwoofer. Note The available speaker channels differ depending on the setting of the speakers. 12 Press ©MENU to exit from “BASIC SETUP”. 23 En