Connecting speakers, Before connecting to the speakers terminal – Yamaha OWNER'S MANUAL HTR-6130 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Connections

Connecting speakers

Be sure to connect the left channel (L), right channel (R),
this unit cannot reproduce the input sources accurately.

’ (red) and (black) properly. If the connections are faulty.

Caution

• Use speakers with the specified impedance shown on the rear panel of this unit.
• If you are to use 6 ohm speakers, be sure to set “SP IMP.” to “6QMIN” before using this unit (see page 12).
• Before connecting the speakers, make sure that this the AC power plug is disconnected from the AC wall outlet.
• Do not let the bare speaker wires touch each other or let them touch any metal part of this unit. This could damage

this unit and/or speakers.

• Use magnetically shielded speakers. If this type of speakers still creates the interference with the monitor, place the

speakers away from the monitor.

Surround speakers

Right Left

Front speakers (B)

Right Left

■ Before connecting to the SPEAKERS

terminal

A speaker cord is actually a pair of insulated cables
running side by side. Cables are colored or shaped
differently, perhaps with a stripe, groove or ridges.
Connect the striped (grooved, etc.) cable to the “+” (red)
terminals of this unit and your speaker. Connect the plain
cable to the (black) terminals.

Remove approximately 10 mm (3/8”) of insulation

from the end of each speaker cable and then
twist the bare wires of the cable together to

prevent short circuits.

10 mm (3/8”)