Panasonic TX-56P800H - Manual (Page 6)

2Э-ОСТ-2004 13:13 FROM
Before Operating This Set
TO operating instr
P.06
Connecting the Piug to the Wall Outlet
Notes;
^ Main plug types vary between countries. The main plug shown at left may therefore
not be the type fitted to your set.
* The On/Oft switch on this model does not full disconnect the TV from the mains
supply.
How to Turn the Power On
Power OFF Power In^licator
No light: Power OFF condition
Note: Even when the Power Switch is "OFF", the TV set
will still consume a small amount of power.
Push the Power switch on Television to turn the set on.
Power ON Power Indicator
□ No light: Normal viewing condition
Red : Stand by
Notes;
* When in the Stand-by condition (Refer to page 11). it is also possible to turn the TV set on by pressing any of the “Direct
Programme Number Selection buttons” ( 0 - 9) or “Programme Number Up or Down buttons" on the TV set or on the Remote
Control.
* if the Wail Outlet is switched OFF or the Main Plug i$ unplugged, when the TV set is again turned ON (by either connecting the
Main Plug to the Wall Outlet or switching the Wall Outlet ON), it will have returned to the original state.
Battery Installation
1
Open the cover.
Apply slight downward pressure
while pulling towards the bottom.
2
Batteries: Use two “R6 (AA)” size
3
Replace the cover,
batteries.
Insert the batteries ensuring the correct
polarities.
This is identifiable by the “+” and symbols
on the batteries and inside the battery
compartment.
Two "R6 (AA)” size
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
A Battery cautions
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
Observe the following precaution:
1. Batteries shall always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example;“Zinc Carbon'^ with “Alkaline").
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when remote control acts sporadically or stops operating the TV set.