Panasonic NV-L25 - Manual (Page 9)

í ^
The adjustments described on this page are not necessary,
if the VTR is connected to the TV set via the Video/Audio
output sockets.
Video Playback Channel Selector
This switch is used to select the Video Playback channel
which is not occupied with any TV station. [NV-L25A: 0 or 1;
NV-L25EA; 2 or 3]
NEL
Q Turn the TV set on and select the programme position
that is not occupied by any TV station.
@ Press the VTR On/Off Switch to turn the VTR On.
(FRONTSIDE)
O
VTR
CO)
• The corresponding indicator lights up.
0 Set the VTR/TV Selector to “VTR".
(FRONTSIDE)
VTR/TV
□
• VTR/TV Indicator will appear in the Multi-Function
Display.
0 Set the Test Signal Switch to “On",
[D
OFF ON
TEST
SIGNAL
0 Tune your TV to VHF channel as shown below.
Confirm by your TV that the received test pattern is as
shown below.
NV-L25A: VHF channel 0 or 1*
NV-L25EA; VHF channel 2 or 3
NV-L25Aonly
*ln some areas
channel 0 may be
used by local TV
station. In this case
switch to channel 1.
0
Set the Test Signal Switch to “Off". Your TV is now
ready to receive the RF output signal from the VTR.
m
OFF ON
TEST
SIGNAL
0 To check, playback a pre-recorded tape and confirm
that the picture quality is satisfactory.