Panasonic NV-L25 - Manual (Page 25)

Make sure that the VTR is turned on.
Make sure that the Timer Record Function is set to “On”.
Select the programme number to be checked, by repeated­
ly pressing the Check/Programme Button.
The preset channel and start and ending times of the timer
recording will be indicated for about 12 seconds.
SP 0 «
(start time)
PROG
(4 seconds) j I
CHECK
2
SP OFF
(end time) =~i (next 8 seconds)
i\iT$
Make sure that;
the VTR is turned on,
the Timer Record Function is set to “Off”.
Press the Check/Programme Button repeatedly, until
the number of the timer programme that you want to
cancel is displayed.
@ Press the ( + ) and (-) Buttons simultaneously for more
than 3 seconds.
•After the programmed timer recording has been
made, set the Timer Record Function to “Off", oth­
erwise the VTR cannot be operated normally.
• During recording, the programme position (channel)
on the VTR cannot be changed.
• When you want to watch TV after setting a timer
recording, select the desired channel on the TV set.
• To cancel a timer recording during recording, set
the Timer Record Function to “Off”.
• It is impossible to confirm programmes of timer re­
cordings while an OTR is being performed.
•To turn the VTR on and use it for playback or re­
cording before the timer recording is performed, set
the Timer Record Function to “Off".
• When the Timer Record Function is set to “On” but
no video cassette is inserted or no timer recording
has been programmed, the Timer Recording Indi­
cator
[2 will flash to inform that the timer recording
cannot be performed.
• If no cassette is inserted in the VTR, the “isg” Mark
will flash.
• Disconnect ail cables from the Video Input and Au­
dio Input Sockets before starting the recording. If
they remain connected, it is impossible to record TV
programmes.
■25/