7 open the disc tray, 2 place a disc, Removing a diso – Panasonic CD-R/RW CF-VCW721 User Manual
Page 8: 3 close the disc tray, Setting a disc, Disc
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Setting a Disc
7
Open the
disc
tray
Press the eject button and slowly pull out the tray
2
Place a disc
Place the disc with the label facing upward in the
drive and push down until the center holder clicks
Place a finger on the center holder and lift up on the edge of the disc 3 Close the disc tray Close the tray without touching the eject button Label side up • Do not apply excessive force to the tray in the open position, doing so could damage the tray I • ' If the PC Card does not work, tliere may be no interrupt request (IRQ) line available j Deactivate unnecessary equipment using m the Setup Utility J /< note > References to “CD" in the Setup Utility will not change when the CD-R/RW Drive Pack IS installed If the vibration of the CD-R/RW drive is excessively high, set [CD Drive Speed] m the Setup Utility to [Low]