Panasonic CD-R/RW CF-VCW721 - Manual (Page 6)

Software Preparation
(first time only)
CWjndo^SSI
Confirm the following contents in [Start] - [Settings] - [Control Panel] - [System] - [Device
Manager] - [CD-ROM] - [MATSHlTA UJDA'''^** ] - [properties]-[Settings] Make the
settings if they have not yet been made
© Add a check mark for [DMA]
• Set both [Start dnve letter] and [End dnve letter] in [Reserc'ed drive letters] to [L ]
Confirm that [Transfer Mode] is set to [DMA if available] in [Start] - [Settings] - [Control
Panel] - [System] - [Hardware] - [Device Manager] - [IDE ATA/ATAPl controllers] - [Sec­
ondary IDE Channel] - [Advanced Settings] - [Device 0] Perform this setting if it has not
yet been made
Using the CD-R/RW Drive Pack in the MS-DOS Mode
iWJnao№98l
To use the CD-R/RW Dnve Pack m the MS-DOS mode* configure the dnve following the
steps below after performing the above preparations If the steps listed below are performed
without completing above preparations first, the drive will not operate properly.
* In the MS-DOS mode, onlj CD-ROM discs arc readable
1 Select [Start] then select [Shut Down)
2
Select [Restart in MS-DOS mode] then click [OK]
3 Open the ' CONFIG SYS” file for editing by issuing the following commands
cd \( Enter )
edit config sys (
Enter )
4 Move the cursor to the line coniaming “OAKCDROM SYS” and delete the characters
“rem” at the beginning ot the line (Deleting “rem ' causes the item to become valid )
DEVICEHIGH=C \WINDOWS\COMMAND\OAKCDROM SYS /D MSCDOOO
(If this line IS missing, add it)
5 Press [ Alt) +C f ) , then C S j to save the file Then press ( Alt) +CE), then (X) to
exit the Edit program
S
Follow the same steps to edit the “AUTOEXEC BAT” file
edit autoexec bat i Enter )
7 Move the cursor to the line containing “MSCDEX EXE and delete the characters “rem '
at the beginning of the line (Deleting “rem ’ causes the item to become valid )
LOADHIGH C \WINDOWS\COMMAND\MSCDEX EXE/D MSCDOOO/L L
(If this line IS missing add it)