Panasonic CF-28 - Manual (Page 25)

ÏO At the confirmation message , press Œ).
The operation of reinstallation for the hard disk starts
automatically.
When the message “insert the next CD” is displayed, in­
sert the Product Recovery CD-ROM showing the next
number in the sequence, and then select [OK.].
(In the case of Windows 2000, only Product Recovery
CD-ROMs 1 to 3 can be used.)
X note >
If [OK] is not immediately selected:
The message “The media does not contain the correct
file” may appear. When [OK] is selected, the message
“insert the next CD” w ill be displayed again.
Confirm that the proper Product Recovery CD-ROM
has been inserted by opening the tray of the CD drive
and then close the tray, then immediately select [OK].
11 After the reinstallation procedure completes, the follow­
ing message will appear on the display. Remove the
floppy disk or Product Recovery CD-ROM, then restart
the computer by pressing (Ctrl ]+
CÂO+ CSD
iW.i^]c^^20T0.01
Windows(R) 2000 Professional install wizard will start after reboot.
Restore process will execute more afta- Windows(R) 2000 Professional install
wizard.
Restart the computer after removing Product Recovery CD-ROM.
Windows(R) XP Professional insmll wizard will start after reboot.
Restore process will execute more after Windows(R)XP Professional install
wizard.
Restart the computer after removing Product Recovery CD-ROM.
14 Using cither[^] or
0
, select [Exit] and then select
[Save Current Values], then press C Enteré,
At the confirmation message, select [Yes] and press
(Enter).
15 Turn the computer off, and then turn the computer on.
16 Perform the setup procedure for Windows by following
the instructions on the screen.
(Refer to the Supplementary Instructions, if they are in-
cluded with the computer.)
Page 11
page 12
i7Run the Setup Utility and change the settings where nec­
essary.
NOTE>
When the message [Operating System not found] is
displayed, press CgHD + (So + ("Pin
and perform the operations from Step
12 to Step 15.
If you fail to press ( F2 ) in Step 12, restart the com­
puter and perform the operations from Step 12 to
Step i5 after finishing Windows setup procedure.
12 When the message [Press F2 to enter SETUP] is displayed,
press ( F2 ) and then run the Setup Utility.
If the password has been set, enter the Superv isor Pass-
w'ord.
13 Press [ F9 ).
At the confirmation message, select [Yes] and press
( Enter ) . (The Setup Utility settings will return to their
default values. Even the security settings with the excep­
tion of the password(s) wall return to their default values.)
X note )-
If there are added functions that are not listed in the
Specifications of this Operating Instructions, we rec­
ommend disabling their device settings. If the set­
tings are enabled, additional operations may be nec­
essary during the Window's setup procedure. (We also
recommend referring to the Supplementary Instruc­
tions, if they are included w'ith the computer.)
25