Step 7: reprogramming the remote control, Inserting or removing a media – Panasonic SC-BT730 User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

STEP 7:
Reprogramming the
remote control
When other Panasonic products respond to this
remote controi
Change “Remote Control Code" (o 38) on the main unit and
the remote control (the two must match) if you place other
Panasonic products close together and it responds to this
remote control.
To change the code on the main unit.
1
While stopped, press [START].
2
Press [ A , T ] to select “Other Functions”
and press [OK],
3
Press [ A , T ] to select
[OK],
4
Press [ A , T ] to select
[OK],
5
Press [ A , T ] to select “Remote Control
Code” and press [OK].
6 Press [ A , T ] to select the code (1 or 2) and
press [OK].
To change the code on the remote control.
1
While pressing [OK]
Press and hold the numbered button
(1 or 2), which has the same number you
selected in the step 6 for more than 5
seconds.
‘Setup” and press
“Others” and press
Inserting or removing a
media
• When inserting a media, ensure that it is facing the right way
up.
• While the reading indicator is displayed, do not turn off the
unit or remove the media. Such action may result in loss of
the media's contents.
• When removing the SD card, press on the center of the card
and pull it straight out.
■ To switch sources
Press [BD/SD] to select “BD/DVD” or “SD”.
• If a media is inserted while the unit is stopped, the source
switches automatically depending on the inserted media.
2
Press [OK].