Panasonic SVGA Monitor/Receiver CT-36DV60 - Manual (Page 33)

Programming the Home Theater Remote
The remote control can be set to control other manufacturers components, by utilizing the MODE SELECTION
BUTTONS for CABLE, DSS, VCR, RCVR {a Receiver or Amplifier), CD, LD, and AUX (for Cassette Players,
Second VCR or a DVD).
Code Known Code Unknown
Now the remote is set for the entered
code.
[
6
]
Code From
Index Sheet
Use the foliowing procedure for setting up the
remote control using the numericai buttons when
the component’s remote code is known.
nn Determine the brand of the component.
f2l Identify the code(s) associated with the
brand from the infrared code index (see
following
pages). Record all possible
codes.
[3] Confirm that the component is plugged in
and operating properly, then turn it OFF.
0i] Press and hold the itedl button, then
the pov^R) button so that both are
pressed at the same time for
mgga'SlSlgC'Onm Then let go of the
buttons.
f5l Press the appropriate MODE button
for the component.
\3\ Enter the 3-digit-code, by using the
Remote Control Keypad “0” through
“9” buttons.
Use the following procedure for setting up the
remote control when the component’s remote
access code is not known. This procedure uses the
“sequence method”.
D
Confirm that the components is plugged in
and operating properly, then turn it OFF.
TNQ2AE012
[Z]
Press the power ) button to test the remote.
If the correct code is setup for the
component (in step [6] ), the component
wili turn on.
Note: Some brands have multiple codes. Repeat
the procedure using another listed code
until the component responds correctly.
Press and hold the button, then
are
for
the powers button so that both
pressed at the same time
gt re^^r5~secohtfS. Then let go of the
buttons.
Press the appropriate Mode button for
the device.
Press the
next code. button to step over to the
B Press the pow ^ r ) button to test the
remote. If the correct code is sent, the
component will turn on.
□ Once the correct code is found, press
y) button to store the code. the ly
Repeat from step H above until the
proper components code is found. It may
take several attempts before the correct
code is found.
Note: If an incorrect code is entered, or when
the operation is not completed within 30
seconds, the settings will not change.
infrared Remote Codes for Specific Components
Helpful Hint: Write down the code numbers for your components in the space provided beiow. This
will serve as a handy reference whenever you need to reprogram your remote control.
CABLE
Cable TV Converter Box VCR
1
Video Cassette Recorder
1
CD
1
Compact Disc Player □ □
□
Uu u
□□□
DSS
1
□ □
□
RCVR
Uu u
LD □□□
Digital Satellite System
'
Receiver or Amplifier Laser Disc Player
n n n u u u
□
□
□
Other Component Other Component Other Component
□
□
□
u u u n □n
Other Component Other Component
j
Other Component
- 3 2 -