Panasonic NV-SD400 - Manual (Page 15)

Storing TV Broadcasts into your VTR
Manual Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or T and
ENTER.
3 Select CH by pressing A or T and then select the
programme position by pressing ◄ or ►.
4 Confirm that CLEAR is set to OFF.
5 Select BAND by pressing A or ▼ and then select TV
band VL, VH or UHF by pressing or ►.
6 Select SEARCH by pressing A or T and then press ►.
r
CMJ SEARCH VH;+i
J
CH2 SEARCH VH
•If the desired TV station is not be tuned, press ► again.
•Press MENU and repeat steps 3-6 for each
programme position you want to tune to a station.
7 Press MENU three times.
Channel Plan
VHF
UHF
VH
NV-SD400A 0-5 5A-12 21-69
NV-SD4Q0EA 1-3 4-11 21-69
NV-SD400A:
Broadcast TV Channel Position tuned on VTR
2 ABC 2
7ATN 7
9TCN 9
10 TEN 10
28SBS 28
Fine Tuning Procedure
1 Press MENU.
2 Select TUNER PRESET by pressing A or ▼ and
ENTER.
3 Select CH by pressing A or T and then select the
programme position by pressing ◄ or ►.
4 Select FINE by pressing A or T .
5 Press or ► to obtain the best tuning condition.
CH2
PtNE +
-/+: •• AFC: ENTER
J
•To return the tuning to its former state, press ENTER.
6 Press MENU.
Blanking of Unoccupied Programme
positions
1 Press MENU.
2 Select TUNER PRESET by pressing A or ▼ and
ENTER.
3 Select CH by pressing A or T and then select the
programme position by pressing or ►.
4 Select CLEAR by pressing A or ▼.
5 Select ON by pressing ◄ or ►.
• Repeat steps 3-5 for another unoccupied programme
positions to skip during the selection of the programme
positions.
•To cancel the blanking of a programme position, select
that programme position and then select CLEAR OFF.
6 Press MENU twice.
§
0)
CO
This table will be required when programming the G-Code.
( 15 )