Panasonic MC-V6602 - Manual (Page 17)

1. Unplug cord from wall outlet 00 NOT drip water on cleaner.
2. Clean exterior using a clean, soft cloth that has been dipped in a solution of mild liquid
detergent and water and wrung dry. Wipe dry after cleaning.
3. To reduce static electricity and dust build-up, wipe outer surface of cleaner and attachments.
4. Wash attachments in warm soapy water, rinse and air dry. DO NOT clean In dishwasher or
clothes washer.
DO NOT USE ATTACHMENTS IF THEY ARE WET.
A
CAUTION
Attachments used in dirty areas, such as under a refrigerator, shouid not be used
on other surfaces until they are washed. They couid ieave marks.
REMOtflNGTOiOOSl
. ■
The hose located on the back of the vacuum cleaner carries the dirt from the nozzle
up to the dust bag. If the hose should become clogged:
1. Unplug the power cord from the outlet
before checking the airflow passages. Pull
open the suction inlet cover and check for
clogging in this area.
2. Disconnect the hose from the nozzle pipe
and check the hose for clogging. Plug in the
vacuum cleaner and turn it on. While running
the vacuum cleaner with the wand disconnect­
ed, stretch the hose in and out to remove the
clog.
Cover
(Suction
Inlet)
. 3. If the clog still exists, turn the vacuum
cleaner OFF and unplug the power cord. Turn
the vacuum cleaner over, exposing the under­
side. Remove the lower plate. Remove the
nozzle pipe by removing screw and retainer
then lift it straight up. Inspect the hose end
and clear it of any obstructions. Reinstall the
nozzle pipe, retainer, screw and lower plate.
See the REMOVING/INSTALLING THE
LOWER PLATE section for detailed instruc­
tions.
-
17
-