Panasonic MC-V6602 - Manual (Page 14)

A
WARNING
Electric Shock or Personal Injury Hazard.
When the lower plate la removed for any reason, before relnatalllng, be sure that all elec­
trical wires are routed In a manner that prevents them from coming Into contact with the
lower plate, lower plate screws, or any moving parts. Be sure that the wires are not
pinched In any way when the lower plate Is reinstalled.
'■ '/>■ .-..I
Before replacing any parts, disconnect the
vacuum cleaner from the electrical outlet.
Replacing some of the parts in this section involves the
removal and installation of the lower plate. Always
place paper under nozzle anytime the lower plate is
removed to protect the floor surface.
To Remove Lower Plate.
Start by placing the handle in the low position. See the HAN­
DLE ADJUSTMENTS section. Turn the vacuum cleaner over,
exposing the underside. Release the lower plate by pressing
the two (2) latches that secure the lower plate inward, as shown in the illustra­
tion. Remove the lower plate and remove any residue that may exist in the belt area.
To Reinstall Lower Plate.
Close the rear belt cover and replace front belt cover. Hook the front end of lower plate onto the
tabs on the front of the nozzle housing. Press the tower plate into place and fasten by pushing
the two {2) latches outward.
NOTE: To ensure maximum cleaning efficiency, the belt should be checked regularly to make
sure it is in good condition. Check to see If tiie belt is stretched, cracked, or if excessive slippage
has occurred. Replace If necessary.
-
14
-