Warning, Gleanijl^lte aältätor) – Panasonic MC-V6602 User Manual

Page 15

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

WARNING

Personal Injury Hazard.

Be careful when removing agitator. The belt tension la high. Failure to do so could
result In personal Injury from agitator releasing quickly and snapping away.

Unptug and turn the unit over. Remove the lower plate as described in the REMOVING/
INSTALLING THE LOWER PLATE section. Lift rear belt cover and remove front belt cover.

Remove the agitator, carefully lift it out, and remove the

worn or broken belt from the brush puiiey and motor shaft.

NOTE: The two end caps may come off aiong with the two

washers as you lift the agitator out. DO NOT lose the two
small washers!

Loop the new belt around the motor shaft and loop it

around the brush pulley. See illustration for correct belt

routing. Use only a Panasonic Type UB4 drive belt.

Before reinserting the agitator make sure the end caps
(rubber) are on correctly. See illustration in

the REPLACING THE BRUSHES section.

Reinstall Agitator

After checking the end caps, reinstall the agitator back into the housing grooves. After installing
the agitator, turn it by hand making sure that the belt is not twisted or pinched and all rotating
parts turn freely. Close rear belt cover and replace front belt cover. Replace the lower plate as
described in the REMOVING/INSTALLING THE LOWER PLATE section.

^glEANijl^ltE AälTÄtOR)

Switch off the vacuum cleaner and unplug the power

cord before cleaning the agitator. In order to keep the
cleaning efficiency high, clean the agitator regularly.

Remove the lower plate if necessary. See the REMOV
ING/INSTALLING THE LOWER PLATE section

for the proper procedure.

Agitator - Cut off any carpet pile and lint
entangled around the agitator with a pair of
scissors as iilustrated.