Unit and cassette information, Erase protection (record tab), Maximum record/playbacktime – Panasonic PV-M1367AD User Manual
Page 5: D.s.t. (dayiight saving time), Spring (first sunday in april), Autumn (last sunday in october), Self-demo mode, Reset aii combination vcr memory functions, Head cieaning, Video heads sensor system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Unit and Cassette Information
Erase Protection (Record Tab)
Cassettes have a record tab to ensure that
recordings are not accidentally erased.
To prevent accidental
erasure, break off the tab
with a screwdriver.
To record again, cover the
hoie with cellophane tape.
I____
Maximum Record/PlaybackTime ]
Only use tapes with the №1 mark in this unit.
Tape Speed
Setting
Type of Video Cassette
T60
T120
T160
SP
(Standard Play)
1 Hour 2 Hours
2 Hours
40 minutes
LP
(Long Play)
2 Hours 4 Hours
5 Hours
20 minutes
SLP
(Super Long Play)3 Hours 6 Hours
8 Hours
[ D.S.T. (Dayiight Saving Time)
spring (First Sunday in April)
When the Combination VCR is set to DST:ON, it
automatically adds one hour and adjusts the clock.
NORMAL TIME
1:00 a.m. 2:00 a.m.
DAYLIGHT
-------- ►
SAVING TIME
3:00 a.m. 4:00 a.m.
Autumn (Last Sunday in October)
When the Combination VCR is set to DST:ON, it
automatically turns back one hour and adjusts the
clock.
DAYLIGHT
SAVING TIME
1:00 a.m. 2:00 a.m.
NORMAL TIME
1:00 a.m. 2:00 a.m.
SELF-DEMO MODE
In Power ON condition, hold down PLAY/REPEAT
on the Combination VCR, with no tape inserted,
for 5 seconds. The demo screen appears.
To cancel: Repeat the above operation. The demo
screen disappears.
Reset aii Combination VCR Memory Functions
Use when moving the Combination VCR to a new location, or if a
mistake was made in the One Time Setup section.
• Make sure a tape is not inserted in the Combination VCR.
1) Push POWER to turn the Combination VCR on.
2) Hold down both the PLAY and REW buttons on the
Combination VCR for more than 5 seconds.
* The power will shut off.
3) Turn the power back on and perform the One Time Setup
section on page 10.
Head Cieaning
Your Combination VCR will not normally require head cleaning,
however the heads may become clogged when playing an old or
damaged tape.
Video Heads Sensor System
If head cleaning becomes necessary, the
Combination VCR will display the screen
at right while playing back a recorded
signal. To exit this screen, push PLAY on
the remote control or Combination VCR.
• Use “dry” type head cleaning
cassette* only.
• Be sure to follow the cleaning tape instructions carefully.
Excessive use of a cleaning cassette can shorten head life.
• If using a head cleaning cassette does not solve the
problem, contact your nearest Factory Service Center or
authorized Service Center. (See page 26.)
'Cleaning cassette part No. NV-TCL30PT is recommended.
VIDEO HEADS MAY
NEED CLEANING
PLEASE INSERT HEAD
CLEANING CASSETTE
OH REFER TO MANUAL
END:PLAY KEY
Product Specifications
Display
Picture Tube:
VCR
Video Recording System:
Audio Track:
Tuner:
Broadcast Channels:
CATV Channels:
FM Radio
Band range:
General
Power Source:
Power Consumption:
13 inch measured diagonal 90°
deflection Picture Tube
2 rotary heads helical scanning system
1 track
VHP 2'-13, UHF 14-69
Midband A through I (14-22)
Superband J through W (23-36)
Hyperband AA-EEE (37-64)
Lowband A-5-A-1 (95-99)
Special CATV channel 5A (01)
Ultraband 65-94, 100-125
87.5-108.1 MHz
120V 60 Hz (AC)
12V (DC)
Power on
Approx. 73 watts (AC)
Approx. 95 watts (DC)
Power off
Approx. 6 watts (AC)
Approx. 9 watts (DC)
EIA Standard NTSC color
1 piece
41°F-104°F (5°C-40°C)
10%~75%
28.6 lbs. (13 Kg)
15-
3/16” (W) XI5-3/16” (H)X
16- 11/16”(D)
386 (W) X 385 (H) X 424 (D) mm
Note: Designs and specifications are subject to change without notice.
Television System:
Speaker:
Operating Temperature:
Operating Humidity:
Weight:
Dimensions: