Panasonic PV-M1367AD - Manual (Page 20)

Timer Recording
Your Combination VCR can be set up to
do a recording while you are away or
otherwise occupied. Up to 8 programs
can be placed in memory. You can
choose to record one time, daily, or
weekly.
kX Check tist before you begin.
□ All connections are made (see page 6).
□ Your Combination VCR is plugged in.
□ The clock is set.
□ The tape is long enough.
□ The record tab is in place.
Push PROG to display
the program screen.
•If a program is already in
memory, push
a
V and ^ to select
an unused program number.
START STOP CH
fè'bXV'' SLP
SELECT START DATE
SELECT :A T KEY
SET :► KEY
END :PROG KEY
Push A V and Oto select and
set one of the following:
1-31 = One time recording
DAILY = Same time MON - FRI
WEEKLY = Same time once a week
Example
Indicator
О © ©*
© © ©
© © @
Ç.C. Dl$fU,Y ÉL£ÈP 04-TIMEf
О a a a
d
STOP
Today’s
Date
^ 8 — 9 ............. 31—1 —2..........
7 SELECTA/T Selection Order
DAILY
(^WEEKLY......... WEEKLY____WEEKLY _J
(SAT) (MON) (SUN)
Push A Vand 0 [>
to select and set
each of the
remaining items at
right.
Remaining Items:
• START time
• STOP time
• CH(annel) number,
or LINE for outside
source recording
• Speed (SP, LP, SLP)
To Make Corrections
Repeatedly pushOto move the cursor to the right, orOto move to
the left to the incorrect entry and make the correction.
Push PROG to end the
program.
• This screen appears for
confirmation.
P DT START STOP CH SPD
2------------
3 ----------
4 ----------
CANCEL
SELECT
ENTER
END ADD/DL
1-8 :A
► KEY
PROG
T KEY
▼ KEY
£Y
To Enter More Programs
Push A V and >to select and set a blank program number, and then
repeat steps 2 and 3.
Push PROG to exit this mode and return to
the normal screen.
• The PROGRAM TIMER indicator lights on the
front panel.
• if you're using a cable box, make sure that it is
tuned to the desired channel and the power is left
on for timer recording.
Two minutes before the Timer Recording starts, “TIMER REC WILL
START SOON" will appear on-screen.
20
If “PLEASE PREPARE FOR TIMER REC" appears and/or the PROGRAM TIMER indicator flashes, check that a
cassette with record tab is loaded and the Combination VCR is in Stop mode.
If the start times of two programs overlap, the lower numbered program will have priority.
If the start time for a timer recording comes up during a normal recording or One Touch Recording (page 19), the
timer recording will not be performed.
If there is a power interruption of more than one minute, the recording may not be performed or continue.
If “INCOMPLETE” appears after all items have been set, check all entries and make necessary corrections.
When using DC Power supply, a Timer Recording can not be performed if POWER on the Combination VCR is pushed OFF.