To rewind or fast forward the tape, To search a particular spot on a tape, Automatic playback relay (deck 2 to deck 1) – Panasonic RX-DT650 User Manual
Page 18: Full autostop
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

You can use either deck 1 or deck 2 for tape playback by following the same steps.
RÉW/HEV FF/CUE
PAUSE
1
C
TAPE
Press TAPE.
2
"'
STOP/
STOPfiJECT
Press STOP/EJECT, insert the
tape and close the cassette
holder.
Reverse side
With the side
to be played
facing you
Press PLAY to start play.
To stop play:
STOP/DECr
Press STOP/EJECT.
To stop play temporarily:
Press PAUSE.
PAUSE
To resume play:
Press PAUSE again.
References
If you leave the unit in the stop mode for about four minutes, it will
lly turn itself off.
Type of tape which can be played on this unit:
Normal/TYPE I
0
Cr02/TYPE II
X
Metal/TYPE IV
X
To rewind or fast forward the tape
REW/REV FF/CUE
In the stop mode, press REVWREV
or FF/CUE.
Do not press PLAY during rewinding or fast forwarding, as this may
jam the tape. Be sure to press STOP/EJECT before proceeding to the
next operation.
To search a particular spot on a tape
REW/REV FF/CUE
During playback, press REW/REV
or FF/CUE.
Tape play is resumed when the button is
released.
Automatic playback relay
(Deck 2 to Deck 1)
When Deck 2 playback has finished. Deck 1 playback starts
automatically.
1
Insert the playback tapes into Deck 1 and Deck 2.
2
Press Deck 2 PLAY.
3
Press Deck 1 PAUSE, then press PLAY.
Full autostop
During playback, recording, fast forward or rewind when the tape
reaches its end, the automatic stop system will release the operation
buttons.