Panasonic RX-DT650 - Manual (Page 13)

Mk
Preset tuning
Make sure you have completed the procedure for “Programming
Broadcast Stations”. (See page 12 beforehand.)
To listen to a station without programming it first, refer to “Listening to
broadcast stations which have not been programmed". (See right.)
Using the main unit
tuner / bjj ^ d I Pr©ss TUNER/BAND to display
“FM” or “AM”.
AM—FM □
(The dispiay changes each time the button
is pressed.)
C/w
I t l
O 1 c
tj t.J
Press PRESET TUNING to select
the preset channel.
The station is changed each time the button
is pressed.
Using the remote control
pp
Listening to broadcast stations which have
not been programmed (Manual tuning)
TUNERm
Press TUNER/BAND to display
“FM” or “AM”.
j— ► AM—►FM— I
(The display changes each time the
button is pressed.)
Press - TUNING + to tune in
the broadcast station.
+ : Press this to increase the broadcast
frequency.
-: Press this to decrease the broadcast
frequency.
FM stations can be selected automatically
(see below).
Lights when an FM stereo
program is picked up.
Lights when a station is
tuned in properly
Seiecting FM stations automaticaliy;
Keep the button depressed until the frequency display starts to change.
A station with good reception is automatically selected and the selection
process then stops.
Frequency display steps:
The frequency display changes in the following steps:
FM: 100 kHz steps
AM: 9 kHz steps
13