Magliner EXTRACTOR HANDLE - Manual (Page 3)

3
EXTRACTOR HANDLE INSTALLATION
Skip Step 1 if the mounting brackets are already installed.
1. Position each of the bottom mounting brackets (A) as illustrated in Figure 3. Fasten with the 5/16” x 1-1/2”
long hex head cap screw (B) and one 5/16” washer (C) on the outside through the uppermost slot. Secure
with the 5/16” lock nut (D) on the inside. (Note: Do not fully tighten until the final handle adjustment is
done.)
2. Use Figure 2 to understand which spring is used on the left-hand side of the truck and which is used on
the right-hand side of the truck (from user position behind the hand truck). Please note that the extractor
handle is mounted to the truck so that it bends away from the truck frame (and toward the operator
standing behind the hand truck).
3. Slide the LH torsion spring (G) onto the left side of the extractor handle (E) making sure the leg pointing
down is positioned in the corner between the mounting bracket and the side rail of the frame as shown in
Figures 3 and 4.
4. Fit the extractor handle with springs (E) through the upper hole in the mounting bracket as shown in
Figure 3. Install a bushing (F) from the outside, and insert a cotter pin (I) as shown in Figure 3 and Figure
5 (page 4).
Figure 2
Figure 3
A
B
C
D
E
F
G
I
LH Side Rail
LH end of
extractor handle
Note: Arrows indicate
direction of spring winding
Figure 4
LH torsion spring (G)
This end is to be
retained by clip on
extractor handle
LH Side Rail
This end is to be trapped
in the corner formed by
the frame and bracket.