Magliner BULK DELIVERY TRUCKS COMMERCIAL AND INDUSTRIAL - Manual (Page 4)

4
C
D
E
F
G
G
H
A
Figure 5
REQUIRED TOOLS
• (1) STANDARD 9/16" WRENCH
• (1) STANDARD SOCKET WRENCH
• (1) STANDARD 9/16" SOCKET
CASTER ASSEMBLY INSTRUCTIONS
Note: If you have the soft drink model, you will only install 3 sets of hardware for each caster on the end of the deck with
the additional end rack sockets as shown in Figure 6. All other casters use 4 sets of hardware. Extra hardware can be
discarded.
1. Using the 3/8"-16 x 1" long hex head screws (F), 3/8"-16 flat washers (G) and 3/8"-16 flanged hex lock nuts (H), attach all
four of the 6" swivel casters (C) onto the deck as shown in Figure 5.
2. Using the 3/8"-16 x 2" long hex head screws (E), the 3/8" washers (G) and the 3/8"-16 flanged hex lock nuts (H), attach
both of the 6" rigid casters (D) onto the deck as shown in Figure 5.
3. Position the handle (B) as shown in Figure 6 and insert it into the sockets of the deck.
NOTE: Tighten all screws securely. (Recommended: The 3/8"-16 screws should be tightened to a torque value of 23 ft-lbs.)
Item Description Qty. Part No.
A Deck - 18" wide x 60" long 1 -
B Handle 2 306150
C Caster - 6" x 2" thermoplastic rubber swivel caster 4 130066
D Caster - 6" x 2" thermoplastic rubber rigid caster 2 130067
Hardware Pack (consists of items below) 1 86625
E Hex head cap screw - 3/8"-16 x 2" long 8 80029
F Hex head cap screw - 3/8"-16 x 1" long 16 80025
G Flat washer for 3/8" bolt 24 80728
H Flanged lock nut - 3/8"-16 24 80624
INDUSTRIAL BULK DELIVERY TRUCK - SOFT DRINK VERSION
Figure 6
B
B9283 © Copyright 2012 Magline, Inc.
Note: 8" caster models use four 8" x 2" thermoplastic rubber swivel casters (130079)
and two 8" x 2" thermoplastic rubber rigid casters (130029).
Side with
addiotional sockets
Additional
socket