Leica Geosystems TPS110C - Manual (Page 70)

Messages and Warnings 70
Messages and Warnings, continued
Message / Warning Meaning / Cause Measure
Calibration
V-Angle not suitable for
calibration ! (Check V-
Angle or face) Aiming tolerance not met or
telescope position/face not
changed.
The target point must be approximately in
the horizontal plane ± 4°30'.
Confirmation of the message required.
Result out of tolerance
and will be rejected ! Computed values out of tolerance.
Previous values retained. Repeat measurements.
Confirmation of the message required.
Hz-Angle out of limit ! Hz-angle in second face/telescope
pos. deviates more than 4°30' from
the target point.
Aim on the target point with an accuracy of
min. 4°30'.
Confirmation of the message required.
Unstable condition or
instrument is tilted !
Try again !
Measurement error appeared (e.g.
instable set up or period between
measuring in telescope position I
and II too long). Repeat the process.
Confirmation of the message required.