Dynon Avionics EFIS-D6 Installation Guide - Manual (Page 20)

Instrument Installation
3-8 EFIS-D6 Installation Guide
Panel Location and Mounting
The diagram at right shows the outside
dimensions of the front bezel of the EFIS-
D6. Note that the instrument is about
seven inches deep and the supplied
harness extends three inches more. Use
the dimensions (in inches) found on the
diagram to plan for the space required by
the instrument. Take the following
considerations into account when selecting
a mounting location for the EFIS-D6.
Avoid placing the instrument near heater
vents or any source of extremely hot or
cold air. Keep in mind that the air
surrounding the EFIS-D6 during
operation may be no warmer than 50
°C to ensure accurate operation. Plan a
panel location that allows convenient
viewing of the instrument with no
obstruction. When flying straight and
level, the panel angle from vertical
may not be greater than +/- 30
degrees. The unit must be aligned as
close as possible with the roll and yaw
axes of the aircraft. The firmware
supports an adjustment for panel tilt,
but not for mounting errors in yaw or roll. Correct attitude performance depends on mounting the
EFIS-D6 square with the direction of flight.
You have two options for mounting the EFIS-D6 into your panel: standard or flush. You may use
the optional flush-mount bracket, allowing the face of the EFIS-D6 to be flush with your panel.
If you opted to receive the flush mount bracket, please skip to Option 2 below. If you opted not
to receive this bracket and wish to
perform the standard install,
follow the options in Option 1
below.
OPTION 1: NO MOUNTING
BRACKET
Using this option, you will be
mounting the EFIS-D6 directly
into your panel. The front bezel of
the unit will extend beyond the
plane of your panel by 0.8”.