Dynon Avionics EFIS-D6 Installation Guide - Manual (Page 13)

EFIS-D6 Installation Guide 3-1
3. INSTRUMENT INSTALLATION
This section provides you with the information needed to physically and electrically install the
EFIS-D6. While the EFIS-D6 includes a built-in electronic compass, it is recommended to install
and calibrate the included EDC-D10A Remote Compass Module.
Selecting a Remote Compass Module Location
Finding a good location for the EDC-D10A
remote compass module is critical to an
accurate EFIS-D6 heading display. Keep in
mind that calibration can compensate for
small static magnetic fields superimposed
upon the earth’s field; it cannot take
into account dynamic effects like
AC currents, non-constant DC
currents and non-stationary ferrous
material (e.g., an electric turn
coordinator). Use the following
suggestions to help you find a good
location for your EDC-D10A.
• Keep the EDC-D10A away from
any source of magnetic fields
(such as electrical equipment and current-
carrying wires) and ferrous material.
• Move a handheld compass throughout the
space surrounding your location to get a ro
idea of the suitability of your chosen location
If the needle deviates significantly from
magnetic north in any given area, that locatio
would not be ideal for the EDC-D10A.
• The EDC-D10A can be mounted anywhe
ugh
.
n
re in
e
at
the aircraft (away from magnetic interference)
such that its pitch is as close to that of the
EFIS-D6 as possible. It does not need to be
directly along any axis of the EFIS-D6. It
should be mounted with the long axis
parallel to the wings, the electrical
connector facing toward the front of th
plane, and the mounting tabs on the
bottom. The bracket used to hold the
EDC-D10A must hold the EDC-D10A
the same pitch, roll, and yaw as the EFIS-
D6 with respect to the airframe. We
recommend that you use an electronic
level, if available, to make sure the EDC-
Connector forward and
tabs mounted down
Connector toward
direction of flight
Side view of EDC-D10A, tabs mounted
down and aligned within 1 degree of pitch
with EFIS-D6