Daiwa TANACOM BULL 500 - Manual (Page 19)

17
Surface depth setting
When the main line is cut or broken off.....
Attention
1. When new line is wound up, or when line has been pulled under heavy tension, line
stretch may cause a gap in the depth reading at the surface. Simply reset the surface
setting with the
RESET BUTTON .
Before you begin fishing, make sure the counter is set to zero at the water’s surface.
This is extremely important to ensure accurate fishing depth readings.
3. Lower the terminal rig to the water’s surface and press the
RESET BUTTON . (water surface zero setting)
The display resets to 0.0 .
2
1. Connect the reel to the battery, put the line through all the
guides, and prepare your terminal rig.
2. Place the rod into the rod holder in the position it will normally
rest while fishing.
- Should your line break, revise data as follows.
- Wind the line to the rod tip, and press the RESET BUTTON for 2
seconds. (At depths greater than 10 m, 2-second-pressing is
employed accidental pressing of the button.) If the display
shows 0.0 then your re-adjustment is complete and data has
been revised.
- Unless you reset the data on the reel, it will not be able to count
accurately.
Functional setting operation
(2. Before you begin fishing.)
3