Daiwa TANACOM BULL 500 - Manual (Page 12)

10
Line data input
(Daiwa braided line)
A special input method can be used when spooling the reel with Daiwa braided line. It is a
useful method because it requires less data input.
1.
Run line through the levelwind guide and tie it onto the spool.
The levelwind threader makes this process easier. Make sure to
tie the line onto the pin found on the spool to avoid the line
slipping.
2. Move the power lever to the OFF position.
1
6
5
Levelwind Guide
Main line Pin
Power lever
2
3. Connect the clip to the power source (12V DC).
4. Attach the cord connector to the reel.
See in page 2 for the connection method.
5. Wind the line to its end with the power lever at maximum.
-Wind line under tension (about 1 kg.).
-Drag should have enough tension to wind line without slipping.
-Be careful not to wind the end of the line onto the reel.
-Do not allow line to rub against the finger guard while winding as
it will scratch the guard.
6.
The display will read 0.0. Press and hold the MODE SETTING
BUTTON for five seconds. When the button is released, the
default setting will show.
8. The power lever can be used to change from the default value
to other line PE values in the reelʼs memory. Once the
appropriate value is displayed, exit the setting display by
pressing the MODE SETTING BUTTON 4 times. The display
will return to 0.0
7.
Default setting “PE 6 – 300 m” is shown on the display and P1
blinks.
The TANACOM BULL 500 has data for the above Daiwa braided lines stored in the
reelʼs memory. Therefore, when winding these lines, there is no need for
additional data input.
PE4
PE5
PE6
PE8
PE10 100
100
100
100
100 200
200
200
200
170 400
350 300
300
300
220 470
Line thickness PE (Display shows PE at upper left of the display) (m)