Daiwa TANACOM BULL 500 - Manual (Page 16)

14
Should “ Err ” appear on the display, then use the MODE SET
BUTTON to re-enter the data.
Line data input
(With backing line)
10
11
8. Press the MODE BUTTON twice and change the display to
backing line input.
P3 will then be blinking.
10. Paying attention to the main line’s color coding, wind the main
line for 50 m. Then hold down RESET BUTTON at least 2
seconds.
(The figure at the bottom of the display will change from 50 to
100.)
11. Similarly, wind the remaining 50 m of the main line and hold
down RESET BUTTON at least 2 seconds.
(When “ 0.0 ” appears on the display, the setting is completed.)
8
9
Tension indicatar
9. As indicated by the line’s color coding, wind the line up until the
remaining line is 100m.
With the power lever moved forward, P3 changes into a tension
indicator. Keep line tension between 3 and 4 while winding.